Universal-remote-control-urs MRX-4SEN Manual de usuario descargar pdf (Pagina 8)

Page 5

Network Installation

WARNING!! Before proceeding, a Custom Professional is required

to install and configure your MRX-4SEN.

Connect the 3.5mm sensor plug to the rear of the MRX-4SEN. When

a change in the sensor’s state is detected, the MRX-4SEN sends a

signal to the MRX Advanced Network System Controller and triggers

a series of commands.

The example below showcases a voltage sensor connected to the

home’s doorbell and the MRX-4SEN. Whenever the door bell is

pressed, a signal is sent over URC’s RF 2.4GHz to the MRX

Advanced Network System Controller. The MRX unit, previously

programmed by the Custom Professional, will trigger a series of

commands or an event to gain your attention. A programmed

event, such as Watch Movie/TV, may pause the movie, mute the

audio and display the front door’s video camera.

MRX-4SEN SENSOR EXTENDER

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Universal-remote-control-urs MRX-4SEN Manual de usuario Pagina 8