Universal-remote-control-urs THZ-100 Manual de usuario descargar pdf (Pagina 40)

Page 36

THZ-100 THERMOSTAT

Troubleshooting Thermostat On-Screen

Notifications

There are notifications on screen for checking the filter, wireless.

If you receive a Check Filter notification then replace the furnace filter

and reset the filter notification as outlined above.

If you receive a Check Wireless notification then check the signal strength

of the THZ-100. If the strength is not excellent then

contact your dealer for more assistance.

If the display shows "Wait..." flashing during the operation of the HVAC system,

the Compression Protection has been activated. Once Compression Protection

cycles, the system can operate as normal. This will help prevent your

HVAC's compressor from turning ON and OFF too quickly.

If the THZ-100 shows a normal Idle state, but the current temperature is

outside the desired temperature, then the Maximum Cycles per hour have

been reached.

In addition, pairing to the MRX Advanced Network System Controller

base unit will be erased and the thermostat will need to go through the

discovery mode to re-establish communications.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Sin comentarios

Universal-remote-control-urs THZ-100 Manual de usuario Pagina 40