Universal-remote-control-urs Universl Remote Manual de usuario descargar pdf (Pagina 29)

Erasing Commands – Overview

You can erase a single learned command, all learned commands in

each component mode, SimpleSound programming, MacroPower

commands, or re-set the remote to original factory default settings,

if desired.

SECTION 1: Erasing a Single Learned Command

STEP 1: To erase a single command, press and hold both the

component button and the ENTER (ENT) button together for

about 3 seconds until the component LED light turns on.

IMPORTANT: If you don’t press a button within 20 seconds, the

LED light will turn off and exit the set-up mode and you will need

to start over.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 111 112

Sin comentarios

Universal-remote-control-urs Universl Remote Manual de usuario Pagina 29