Universal-remote-control-urs MX-600 Manual de usuario descargar pdf (Pagina 4)

Thank you for purchasing the MX-600 RF/IR remote control. You

can use the MX-600 line of sight with your components via IR

(infrared) and/or with the companion MRF-100 base station. The

base station will enable you to place your audio/video components

out of sight behind closed doors and/or in another room of your

house. The MX-600 sends RF (radio frequency) signals to the

MRF-100 throughout your house (50-100 feet, indoors or

outdoors).

The MRF-100 converts your commands to the infrared signals that

control your A/V components.

1.The MX-600 remote control sends

radio waves in every direction, so

you don't have to point the remote

anymore!

2.The MRF-100's built-in Front Blaster sends commands to

components in the same cabinet space as the MRF-100.

3. Self-adhesive

“

Flashers

”

affix to the Infrared sensors on the

front panels of your components. The Flashers relay commands to

components out of sight of the MRF-100’s Front Blaster. The

flashers plug in to the MRF-100’s rear flasher line outputs via their

10 foot cables.

Note: Components with original RF remote controls cannot be operated by

the MX-600 unless the component can be switched to Infrared control

via it's internal menus.The MX-600’s RF signal only communicates

with the MRF-100 base station (which converts it to Infrared signals).

1. Introduction

1 2 3 4 5 6 7 8 9 ... 79 80

Sin comentarios

Universal-remote-control-urs MX-600 Manual de usuario Pagina 4