Universal-remote-control-urs URC-300 Manual de usuario descargar pdf (Pagina 11)

9

URC-300

When the display shows “MAIN”, you are back in

normal operating mode. Now it’s time to test all

the buttons. If some buttons don’t work, try

repeating steps 1-9, to see if you can improve the

match to your component.

For Example: My Sony TV powered off with TV

code number 139. However the number buttons

didn’t work when I tested them. So, I repeated

steps one to ten, using other code numbers and

eventually discovered that when code number

185 is set, all the buttons work perfectly.

Repeat steps one through nine for each of your

devices. In most systems, you can finish basic

setup in just a few minutes and put all your old

remote controls away.

If you are still missing commands to control any

of your devices, use the Learning Method on the

next page.

10

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Comentarios a estos manuales

Sin comentarios